Twin Rail LED Hanging System - D-D

D&D The Aquarium Solution

H26 RAIL 36 - H

Type: Light

D-D Twin Rail Hanging System
The D-D rail system is an anaesthetic solution to the installation of multiple Aquaillumination LED lights above an aquarium and is manufactured from an annodised aluminium section with stainless steel end plates, with built in cable management system.

The rail set shown is the version for wider format lights such as the HYDRA 52, HYDRA, VEGA & SOL. A separate version for the HYDRA 26 is also available.


  • Aesthetic anodised aluminium custom section with stainless steel end plates.
  • Suitable for suspended or tank mounting (optional parts required).
  • Integrates with fully modular concept.
  • Designed with integral cable management system.
  • Infinitely adjustable hanging positions along the whole length of the rail.
  • Fully height adjustable by using AI WIRE 03 kit.
  • Strong and lightweight in a range of lengths.
(Alternative single rail version available to allow the lights to be orientated along the length of the rail)

Cable Management
Variable Hanging Height

Variable Hanging Position

Available sizes

As standard supplied in 2, 3, 4, 5 and 6 foot lengths but can also be cut down to custom sizes at home if required.
Hanging wires or tank mount feet are sold separately as options.


HYDRA 52 Format
Product Code SOL RAIL X - H ( where x = length in inches 36, 48, 60, 72)
HYDRA 26 Format
Suitable for HYDRA 26 HD, HYDRA 26
Product Code H26 RAIL X - H ( where x = length in inches 36, 48, 60, 72)
Photo shows how multiple rails can be used to cover a large area. (Hydra 26 Rails).

Hanging & Mounting Options 


This wire kit is designed for use with the D-D rail system and has a ball on each end of the Y connector so that you can slide the wire to any position and to any angle along the length of the rail for maximum flexibility.


Used as an alternative to hanging the D-D twin rail system. The feet slide into a groove on the bottom of the rail and are designed to sit on the upper edge of the tank or hood, Lifting the height of the rail by 6 inches.
(Note that the feet are manufactured for a slightly different section and will require slight trimming of the plastic with a knife during installation).

    Related Items